| Output Power |
1100W max at low line and 1400W max at high line. |
| Output Voltage |
54V |
| Line regulation |
+/-5% |
| Load regulation |
load line, output voltage vs. output current with 2V droop. |
| Ripple & Noise |
< 520mV pk-pk |
| Rise time |
< 400 mS |
| Turn On Delay |
< 3 sec |
| Dynamic response |
Output shall be within 2V outside droop range for current step change of 10% -100% of full load. |
| Over current protection |
115-125% of Full load |
| Short circuit protection |
Protected for continuous short circuit. Recovery after removal of short circuit. |
| Over voltage protection |
Latching Type |
| Current share |
Current sharing via droop method. |
| EEPROM & I2C bus |
PS with a serial EEPROM communicates information to the system processor through I2C bus |
| Microcontroller |
PSU remote shut off, LED status monitored and controlled through microcontroller. |
| Thermal protection |
PWM Converter disabled when the internal temperature exceeds safe operating range |
| Under voltage |
Capable to withstand any input under voltage for unlimited time without damage. |
| Power Fail signal |
A Positive True Open collector signal. Issues Power Fail Signal 2mS before O/P goes out of Regulation |
| Fan fail |
Power Fail signal also indicate warning of an internal fan failure |
| Hot swapping |
Hot swappable |
